Material And Hardness Scales Settings - DGC DHT-100Plus Instruction Manual

-Press the
-Press the
-Press the
-Press the
Notice: During measurements, the actual impacting direction must
conform to the one selected.

6.3.2 Material and hardness scales settings

During measurement performance, the material set must conform to the
actual measured material. DHT-100Plus hardness tester supplies 9 kinds of
materials for actual measurement. For each material, there is accordingly
different hardness scales. For details, please refer to appendix 2 and 3.
Before measurement, users should firstly confirm the measured materials
and the corresponding hardness scales. Set the proper materials and hardness
scales as following:
- Press the
- Press the
- Press the
- Press the
Hardness Tester DHT-100
key and the
key to enter this item,
key or key for setting,
key to confirm.
key and the
key to enter this item,
key or key for setting,
key to confirm.
PLUS
key to enter MEASURE- DIRECTION.
key to enter MEASURE- MATERIAL-SCALE
9