Kalorik WFVC 44452 Manual page 17

• Take off the reservoir cover. Empty the reservoir and wash
thoroughly.
• Pull out the tube head. Turning the inner tube in an anti-clockwise
direction to the unlock position. (Fig.17)
• Empty the reservoir by pouring out the dirty water. (Fig.18)
• Wash the cover, tube head, inner tube and active carbon fiber
with tap water, let it dry completely before reinserting back into the
reservoir cover.
• Close and lock the top lid. Put the reservoir back into the chamber
and lock it.
FLOOR NOZZLE AND BRUSH MAINTENANCE
• When cleaning the floor brush, lay the vacuum cleaner flat on the
floor to take the floor nozzle out.
• Press and hold the floor nozzle release buttons at the same time as
indicated below and pull out the floor nozzle. (Fig.19)
Slowly rotate the brush manually and remove any foreign objects
•
tangled around the roller brush. (Fig.20)
If the brush cannot be smoothly rotated:
1. Pull backward (a) and dislodge the brush cover (b). (Fig.21)
2. Lift up the left side of the roller brush and then remove. Then remove
the blockage and take out any waste. (Fig.22 & 23)
3. Re-install the rotating brush again. Finally, check if the brush cover is
securely fixed and the roller brush easily rotates properly with your
hand. (Fig.24)
BATTERY DISPOSAL
• When the battery pack can no longer maintain a charge, the
product, it must be removed and recycled in accordance with the
federal and local laws before discarding.
• Before releasing the battery pack, make sure the vacuum cleaner is
turned off and disconnected adaptor disconnected from the
power outlet.
• Take out the handle cover. (Fig.25)
• Unscrew all the screws on the housing. (Fig.26 & 27)
www.KALORIK.com
17
WFVC 44452 - 180330