Daymak BOOMERBEAST 2.0 STANDARD User Manual page 8

Boomerbeast Operation (cont'd)
Turning on your unit
Handlebars, on each unit you will nd a few buttons and switches. Here is what everything does.
Right Handle Bar
1) Front Brake - Pull this lever to engage the front brake.
(Use the rear brake rst located on the left handle
bar.)
2) Throttle - Slowly rotate this towards you to engage
the motor.
*PLEASE NOTE* Always be sitting on the unit before
turning the throttle.
3) Horn - Push this to honk the horn.
4) Lights - Push this to the right most position to turn on
all lights. Push this to the middle position to have just
the rear lights on. Push this to turn o all the lights.
5) 3 Speed Switch - Choose between 1 of 3 speeds.
Position 1 will get you the furthest range at the slow-
est speed. Position 3 will get you there fastest with the
shortest range.
8
Left Handle Bar
1) High Beam / Low Beam - Toggle this switch to choose
between a low or high angle of the headlights. (The
headlight must be on for this to have an e ect)
2) Turn Signals - Push this to the left to indicate turning
to the left and into the middle once your done. Push this
to the right if you are turning to the right.
3) Reverse switch - Press and hold this while engaging
the throttle to go in reverse.
*PLEASE NOTE* Always be aware of your surround-
ings when operating this in reverse and use it at your
own discretion
4) Horn - Push this to honk the horn.