Table of Contents
Advertisement
When the value of the servo parameter is negative, a minus is displayed in the first digit. The example for in the case of "-
1234567890" is displayed.
Press the "MODE" button once.
External I/O signal display
The on/off states of the digital I/O signals connected to the servo amplifier can be confirmed.
Operation
The display screen after power-on is shown. Press "MODE" to display the diagnostic screen.
Press the "UP" button twice.
Display content
The 7-segment LED segments and CN3 connector pins correspond as shown below. The CN3-13 pin and CN3-14 pin can be
used on the MR-J5-_A-RJ servo amplifiers.
CN3-10/CN3-37
CN3-42
Input signal
Always lit
Output signal
CN3-14
The LED segments corresponding to the pins are lit to indicate on, and are extinguished to indicate off. For pin signals in each
control mode, refer to "Connectors and pin assignments" in the following manual.
MR-J5 User's Manual (Hardware)
3 STRUCTURE
40
3.2 Switch setting and display of the servo amplifier
Press the "MODE" button once.
External I/O signal display screen
CN3-35/CN3-38
CN3-45
CN3-18
CN3-17
CN3-13
CN3-33
Press the "MODE" button once.
CN3-16
CN3-41
CN3-19
CN3-48
CN3-22
CN3-25
CN3-15
CN3-44
CN3-43
CN3-23
CN3-24
CN3-49
Light on: on
Light off: off
Advertisement
Table of Contents
