Control Board
The Quilt Maker Pro 18 VERSA machine has the control board mounted inside the main front cover casting.
The main control board uses the following 8 connections (all are labeled with the name except the
handlebars which are labelled J18 and J 17):
• RED/BLK power connection - top right of board
• Encoder, speed needle sensor for main shaft
• Motor Driver
• Handle Bar Connection (J18)
• Handle Bar Connection (J17)
• Power (for handle bar remote power switch)
• Tension (for front display readout)
• Lighting (for built in light ring)
The three circled connections below are not used on the control board: Test, Thread Sensor and Speaker
Janome-America.com
Page 33