Table of Contents
Advertisement
1. General Observation - Continued
Figure 1.4
Page 8
3 . Check/Inspect: Test the condition of the thread
guides, the takeup/check spring, the take-up
lever, the thread stirrup and the needle bar
thread guide. Check for any abrasions, cuts, or
electroplating blistering. Test each guide by flossing
it with thread, left to right and front to back in all
directions, checking for any sharp defects that may
damage or cut the thread . Replace any damaged
parts .
Quit Maker Pro 18 VERSA
Advertisement
Table of Contents
