Table of Contents
Advertisement
16. Adjusting the Needle Height with Cylinder Tool – Continued
Figure 16.5
4 . Slide the cylinder tool gently against the needle (Figure 16.5).
5. Sight through the needle eye and compare the upper and lower levels of the eye with the cylinder tool
groove (Figure 16.6). If an adjustment is necessary, loosen the needle bar driving clamp slightly and raise or
lower the needle bar.
6. Reinstall the hook and set loop lift at 2.2 mm and reset needle distance. (See Adjustment of the Loop Lift
and Needle Distance Section)
17. Electronic Adjustments and Indicators
System Power
The Quilt Maker Pro 18 VERSA operates at voltage
levels between 100 and 240VAC, 50 or 60 Hz. This
means it can be run in most countries as long as the
appropriate power cord or adapter plug is used. If
an adapter plug is used, please be sure the adapter
connects the Earth Ground as well as the Line and
Neutral prongs of the plug. An improper or non-
existent earth ground connection will lead to sporadic
and potentially dangerous operating conditions of the
machine .
Janome-America.com
Figure 16.6
Page 29
Advertisement
Table of Contents
