Table of Contents
Advertisement
AlertMaxx
8.0
Connecting a finger float to the AlertMaxx unit
1.
Using a draw cord, pull the float cable through the cable duct on the chamber.
2.
Insert a large cable gland into the second from right hole of the AlertMaxx unit.
3.
Pull the float cable through the small cable gland on the AlertMaxx unit.
4.
Connect the blue and a brown cable from the float switch cable to the terminal strip (see figure 4).
If the cable supplied with the float switch is too short, the cable can be extended using a cable with a
N
E
8
PLEASE NOTE
minimum core cross sectional area of 1mm².
BLUE
BROWN
40
BLACK
BROWN
120
80
Figure 4. Wiring a finger float switch
For technical support, please call 01279 757400
Advertisement
Table of Contents
