Advertisement
Kirby Morgan Dive Systems, Inc.
1430 Jason Way Santa Maria, California 93455
Phone: 805/928-7772
www.KirbyMorgan.com email: kmdsi@KirbyMorgan.com
530-556
© MMXVIII Kirby Morgan Dive Systems, Inc. All Rights Reserved
Fax: 805/928-0342
530-043
530-040
6) Thread the rear handle mount screw and washer
into the top weight. DO NOT TIGHTEN.
7) Tighten screws. Torque the front handle and the bracket mount screws
first. Torque to 12 inch pounds.
DO NOT OVERTIGHTEN SCREWS!
Over torquing these screws can cause severe damage to the helmet shell
and the port retainer threaded inserts. Always use a torque screwdriver to
tighten any port retainer screws.
8) Torque the handle and accessory mounting screws on the top weight to
35 inch pounds.
®
5) Position the handle on the helmet and
align all the holes. Install new screws P/N 530-
043. First install the 2 outer screws, but DO
NOT TIGHTEN. Slide the washer P/N 530-556
between the handle and the port retainer and
install the center handle screw through the
washer. DO NOT TIGHTEN.
Document #180905001
Page 2 of 2
Advertisement
