Maintenance; Technical Data - Husqvarna DB110 Operator's Manual

Introduction
Below you will find some general maintenance
instructions. If you need further information please
contact your service workshop.
To do daily maintenance on the
attachment
WARNING:
the motor and remove
the battery before you
clean or do maintenance
on the attachment.
WARNING:
of your body away from
hot surfaces.

Technical data

110iLD or 110iL + Blower attachment DB110
Weight
Weight without battery, kg
1
Noise emissions
Sound power level, measured dB (A)
Sound power level, guaranteed L
2
Sound levels
Equivalent sound pressure level at the operator's ear, measured according to EN
50636-2-100 and ISO 26868, dB (A)
3
Vibration levels
1
Noise emissions in the environment measured as sound power (L
2000/14/EC. Reported sound power level for the machine has been measured with the original cutting
attachment that gives the highest level. The difference between guaranteed and measured sound power
is that the guaranteed sound power also includes dispersion in the measurement result and the variations
between different machines of the same model according to Directive 2000/14/EC.
2
Reported data for sound pressure level for the machine has a typical statistical dispersion (standard deviation)
of 3 dB (A).
3
Reported data for vibration level has a typical statistical dispersion (standard deviation) of 1.5 m/s
2201 - 005 - 26.10.2023

Maintenance

Always stop
Keep all parts
Technical data
dB (A)
WA
1. Clean the external surface of the blower.
2. Make sure that the housing have no cracks.
3. Make sure that the product operates correctly.
4. Make sure that all nuts and screws are tight.
5. Use a moist cloth with a mild detergent to clean the
labels.
To do a check of the air intake
1. Stop the product.
2. Make sure that the air intake is not blocked on all
sides, including the bottom, for example by leaves or
waste. Remove blockage if it is necessary. (Fig. 25)
CAUTION:
decreases the blowing capacity of the
product and increases the temperature
of the motor, which can cause damage
to the motor.
2.62
90
92
82
) in conformity with EC directive
WA
A clogged air intake
2
.
11