Maintenance; Introduction - Husqvarna 230iB Operator's Manual

3. Press the lower part of the battery and
push it in as far as it will go into the
battery compartment. The battery will lock into
position when you hear a click.
4. Make sure that the latches snap in place
correctly. (Fig. 26)
To start the product
1. Push and hold the power button (A) until the
green LED light (B) comes on. (Fig. 27)
2. Use the power trigger to control the speed.
To stop the product
1. Release the power trigger.
2. Push and hold the power button until the
green LED light comes off.
3. Remove the battery from the product. Push
the two release buttons and pull out the
battery. (Fig. 28)

Introduction

WARNING:
maintenance work you must read and
understand the safety chapter.

Maintenance

Clean the outside of the machine with a clean and dry cloth. Never use
water.
Keep handles dry, clean and free from oil and grease.
Make sure that the power button works correctly and is not damaged.
Make sure the power trigger is functioning properly with regard to
safety.
Check that nuts and screws are tight.
Check that the battery is intact.
Check the battery's charge.
Check that the release buttons on the battery works and locks the
battery into the machine.
Check that the battery charger is intact and functional.
Check that all connections are intact and free from dirt.
16
Maintenance
Before you do any
To set the optimal airflow for your work
1. Push the power trigger and hold it at the
optimal airflow for your work. (Fig. 21)
2. Push the cruise control button to set the
selected airflow. The LED comes on. (Fig. 29)
3. Continue to operate the product without the
power trigger pushed. (Fig. 30)
4. Push the cruise control button again to stop
the cruise control function.
To temporarily increase the airflow
1. Start the product. Refer to
on page 16 .
2. Push the power boost button to get the
maximum airflow. The LED comes on. (Fig.
31)
3. Release the power boost button to use the
product with the initial air flow.
Maintenance schedule
WARNING:
before you do maintenance.
The following is a list of the maintenance steps
that you must do on the product.
To start the product
Remove the battery
Daily Weekly Monthly
X
X
X
X
X
X
X
X
X
X
1516 - 008 - 29.11.2023