Alarming Per Udp Client - W&T IP-Watcher 2x2 Digital PoE Manual

W&T
IP-Watcher 2x2 Digital PoE
Finally, configure the require message texts as described in the
section Formulating message texts and save the changes by
clicking on Save.

4.9 Alarming per UDP client

Go to page
Config >> Device >> Basic Settings >> UDP
and select the option UDP enable and click on Save to apply
the change
Configure the alarm condition for the desired alarm as
described in the section Configuring alarms.
Go to page
Config >> Device >> Alarm >> Alarm X >> UDP
and in the field IP Addr enter the IP address of the UDP server.
For Port specify the destination port.
Finally, configure the require message texts as described in the
section Formulating message texts and save the changes by
clicking on Save.
53