Husqvarna 524LK Operator's Manual page 19

4. Push the unwanted oil out of the air filter while in the
plastic bag.
Bevel gear
The bevel gear is filled to ¾ with grease at the factory.
Before you use the product, make sure that the grease
level has not changed. Use Husqvarna special grease if
it is necessary to fill up. Do not replace the grease in the
bevel gear. Let servicing personnel do the repair of the
bevel gear.
Maintenance
Clean the external surface.
Make sure that the throttle trigger lock and the throttle works correctly from a
safety point of view.
Do a check of the stop switch to make sure that it works correctly.
Make sure that the cutting attachment does not rotate at idle speed.
Clean the air filter. Replace if necessary.
Examine the cutting attachment guard for damages and cracks. Replace the
guard if it has been exposed to impact or is cracked.
Examine the trimmer head for damages and cracks. Replace if damaged.
Make sure that the screws and nuts are tight.
Examine the engine, the fuel tank and the fuel lines for leaks.
1309 - 001 -
Maintenance schedule
The following is a list of the maintenance steps that must
be performed on the product. Most of the items are
Maintenance on page 16
described in
Note: The user must only carry out the maintenance and
service work described in this operator's manual. More
extensive work must be carried out by an authorized
service workshop.
Daily Weekly Monthly
X
X
X
X
X
X
X
X
X
19