White Rodgers 1F95-80 Operation Manual page 13

displayed. If the switch is OFF (down), use
a pencil or small screwdriver to move the
switch to the ON position (see figure be-
low). Remove the battery for at least two
minutes, to allow the thermostat to reset
itself. Replace the battery and put the ther-
mostat back on the wall. Press
until the desired operating mode is dis-
played.
EMR (ON)
ON
1 2
Switch #1 set at installation (DO NOT CHANGE)
Switch #2 set at installation (DO NOT CHANGE)
Switch #3 ON
Switch #4 (see TOTAL KEYPAD LOCKOUT)
SYSTEM
SWITCH
3 4
To disable EMR, press
is displayed. Remove the thermostat body
from the wall and use a pencil or small
screwdriver to move option switch #3 to the
OFF (down) position. Remove the battery
and allow at least two minutes for the
thermostat to reset itself. Replace the bat-
tery, press SYSTEM
SWITCH
then replace the thermostat on the wall.
SYSTEM
Press until the desired operating
SWITCH
mode is displayed.
• AUTOMATIC CHANGEOVER — If your
thermostat was configured for this option
at installation, you can set the thermostat
to automatically switch the system from
heating to cooling as needed. Press
SYSTEM
to set the thermostat to AUTO (the
SWITCH
SYSTEM
until OFF
SWITCH
until OFF is displayed,
13