Table of Contents
Advertisement
Table 12-4
Parameterization Errors
Error Code
M7CNTE_PAR_ENC_SEL
M7CNTE_PAR_WIRE_BRK
M7CNTE_PAR_SIG_EVAL
M7CNTE_PAR_FIL_CNT
M7CNTE_PAR_FIL_DI
M7CNTE_PAR_SIG_INV
M7CNTE_PAR_METH_DQ0
M7CNTE_PAR_METH_DQ1
M7CNTE_PAR_PULS_DUR
M7CNTE_PAR_HYST_VAL
M7CNTE_PAR_OP_MOD
M7CNTE_PAR_SW_HW_GATE 212
M7CNTE_PAR_DIR_IMP_AL
M7CNTE_PAR_AL_GATE
M7CNTE_PAR_AL_METH_DQ
*
See M7CNT_PARAM structure, Table 12-1
**
With IF 961-CT1 counter submodule only: if both digital outputs are enabled, the same behavior (pulse behavior or
range behavior) must be parameterized for both. If only one digital output is enabled any behavior can be parameterized
for it.
FM 450-1 Counter Function Module
C79000-G7076-C450-01
www.gkbpx.com
M7 Reference Counter Function Library
No.
Meaning
201
Coding for receiver selection
wrong
202
Coding for diagnostics of the sig-
nal pair wrong
203
Coding for the evaluation of the
signals wrong
204
Coding for input filter counter in-
put 24 V wrong
205
Coding for input filter digital in-
puts wrong
206
Change of direction not permissi-
ble
207
Coding for behavior of Q0 wrong
Coding for behavior of Q1 wrong Please change the relevant param-
208
209
Pulse duration too long
210
Hysteresis too great
211
Wrong operating mode
Both gate types or no gate type
specified
215
Direction for pulse output and
process interrupt must be same
216
Interrupts from internal gate only
possible in operating mode with
gate
217
Output behavior and interrupt
mask (first word) do not match**
Remedy
Please change the relevant param-
eter of the M7CNT_PARAM*
structure or – in the case of the
FM 350-1 – the coding key.
eter of the M7CNT_PARAM
eter of the M7CNT PARAM
st uctu e
structure*
12-31
该文档是极速PDF编辑器生成，
如果想去掉该提示,请访问并下载：
http://www.jisupdfeditor.com/
12
Advertisement
Table of Contents
