Tools and materials
Required:
• #1 and #2 Phillips screwdrivers or sockets
• 1/4" angled wrench and 1-1/2" open ended
• Drill and appropriate bits
• Custom grille panel
• Safety glasses
• Gloves to protect against
Parts List:
A. Soffit Vent Top
B. Left Side Case Trim
C. Right Side Case Trim
D. Center U-Shape Trim
E. Grill Base Wrap
F. Stainless Steel Unified Panel
G. Foam Spacer Pads
Step 1
Install Spacer Pads,
Replace Side Case
Trims
• Apply the supplied foam spacer pads to the mating
wrench
sharp edges
CAUTION: Handle parts with care to avoid scratching.
In a side by side installation, the inside case trim of
both products will be removed and replaced with a
shorter trim.
• Lift up to remove the supplied grille panel assembly
on both products. Discard both assemblies.
side of one product as shown.
ZUGSS Trim Kit
Completion Time: Allow approximately 3 hours to
install this kit.
IMPORTANT: 2 People are required to install this kit.
CAUTION: Disconnect power before you begin.
A
B
C
D
E
F
G
Foam
• Remove the Phillips head screws from the inside case
Spacer
trim of each product as shown. Remove and discard
Pads
side trim. Retain screws.
• Install new side case trim with notches towards the
bottom. Install with original screws.
Unified Stainless Steel Custom Grille Panel
15