Advertisement
Available languages
Available languages
CLEANING
AND
MAINTENANCE
PRECAUTION
INSTRUCTIONS
-
IMPORTANT:
cleaning
and
disconnect the equipment from the mains
power supply:
-
high temperatures can be reached inside the
machine (90°C). After power supply has
been removed, wait until the machine has
reached
the
room
working on it.
-
The machine protection degree is IP21,
therefore it should not be washed with direct
high pressure jets of water.
-
Never leave tools, parts or other loose
material on or in the machine.
-
Before starting machine or cycle, after any
maintenance or repair work, make sure all
protective are correctly installed.
POSSIBLE TROUBLES - CAUSES - SOLUTIONS
PROBLEMS/ALARM
The machine doesn't catch
The water doesn't go in
Insufficient Washing
Insufficient Rinsing
The lamp "H" lights up
PREVENTIVE
AND
CLEANING
Before
carrying
out
maintenance
operations,
temperature,
before
CAUSES
Main switch is switched off
Water cock closed,
The Overflow is not in its place
Wrong detergent or dosage
Insufficient,
Low temperature in the tank,
Dirty wash filter
Rinsing nozzles blocked,
Hydraulic pressure lower than
1 bar - 100 kPa
Salt exhausted
CAUTION! FOR ANY OTHER TROUBLE, CALL SERVICE
DAILY MAINTENANCE
-
Disconnect the machine with pushbutton
"A";
-
Lift
drain out of the tank;
-
Wash thoroughly the tank and
the
housing to remove all the impurities;
-
Take the filters and clean them under
running water;
-
Re-assemble the overflow
filters in their housings;
-
Check and clean the washing and the
rinsing jets;
-
Clean the outer surface of the machine by
using a w et sponge; don't use water jets
because, besides being dangerous they
could damage the electrical parts; don't
use abrasive detergents;
-
When the machine is to remain idle for a
long time, drain all the water
boiler and
Also leave the wash tank open.
NEVER WASH THE EXTERNAL PART OF THE
MACHINE WITH A WATER JET
23
the
overflow pipe and let the water
from the
electropump.
SOLUTIONS
Turn ON the main switch
Open water cock,
Reassemble the Overflow in its
place
Use anti-foam detergent in the
right dosage and never with
cold water,
Wait untill the water gets hot,
Clean the filter
Unscrew and clean nozzles
under running water,
Wait until the pressure is on or
buy a booster pump
A
dd salt in the container
(see page 22)
the filter
pipe
and the
from
the
Advertisement
