Attaching And Replacing Roughing / Grinding / Cutting Discs; Switching On And Off; Maintenance And Cleaning - Parkside PWS 230 A1 Operation And Safety Notes

Attaching and replacing
Q
roughing / grinding / cutting discs
Take note of the dimensions of the roughing /
grinding or cutting discs. The circular hole must fit
on to the mounting flange without play. Do not use
a reducer piece or adapter.
Pull the mains plug out of the mains
socket before you carry out any task
on the device.
C heck the condition of the roughing /
grinding or cutting discs. They must be
free of damage, moisture or cracks.
Otherwise they could break up during use and
cause injury.
DANGER OF BURNS! Always wear
protective gloves when changing a
roughing / grinding or cutting disc.
Roughing / grinding and cutting discs become
hot during use. Do not touch them until after
they have cooled down.
N OTE: Always ensure the discs are free of dirt
before use.
U se only abrasive consumables or tools with
an allowable speed at least as high as the
no-load speed of the device.
D ANGER OF INjURy! Press the spindle lock
button only after the mounting spindle
11
has reached a standstill.
P ress the spindle lock button
R elease the clamping nut
(see Fig. C).
17
P lace the roughing / grinding or cutting disc on
to the mounting flange
facing towards the device.
T hen replace the clamping nut
raised side facing upwards, on to the mounting
spindle .
14
P ress the spindle lock button
T ighten the clamping nut
spanner .
17
N OTE: Replace a new disc immediately if it
runs unevenly or vibrates after being exchanged.
A fter replacing a disc let the device run under
no-load conditions for 30 seconds as a safety
check. Look out for unusual noises or generation
Preparing for use / Operation / Maintenance and cleaning
DANGER OF INjURy!
14
to block the drive.
11
using the spanner
13
with its labelled side
15
, with its
13
to block the drive.
11
again with the
13
of sparks. Check that all the fastened-on parts
are correctly attached.
P ay attention to see that the arrow showing the
direction of rotation on the roughing / grinding
or cutting discs (including diamond cutting discs)
corresponds with the direction of rotation of the
device (see arrow on the head of the device).
Operation
Q

Switching on and off

Q
Note: Always switch on the angle grinder before
bringing it into contact with the workpiece material.
Switching on the device:
P ress the safety lock-out
Then press the ON / OFF switch
Switching off the device:
R elease the ON / OFF switch
Rotating the hand grip:
Pull the mains plug out of the mains
socket before you carry out any task
on the device.
T he hand grip can be rotated by 90° to
1
the right or left (see Fig. A).
T his allows the ON / OFF switch
brought into the most comfortable position for
any working conditions.
P ress the unlocking button
hand grip to the right or left.
1
M ake sure the hand grip

Maintenance and cleaning

Q
Pull the mains plug out of the mains
socket before you carry out any task
on the device.
D o not use sharp objects for cleaning
the device. Do not allow any liquids
to enter the device. Otherwise the device
could be damaged.
(see Fig. H).
3
.
2
.
2
DANGER OF INjURy!
to be
2
and rotate the
4
engages.
1
DANGER OF INjURy!
GB/MT 31