Programming The Immobilizer System - PIAGGIO LUM Beverly Sport Touring 350 ie Manual

Programming the immobilizer system (01_21)

Below is described the procedure to follow for programming the PIAGGIO IMMOBIL-
ISER system and/or for storing other key codes. The programming procedure should
be carried out with the engine stop switch set to «RUN».
START PROCEDURE
Insert the «MASTER» key «A» into the ignition switch (in «OFF») and turn it to
«ON». After 1 - 3 seconds, turn the key to «OFF » again and pull it out.
INTERMEDIATE STAGE
After extracting the «MASTER» key «A», insert, within ten seconds, the key that is
going to be programmed «B» and turn it immediately to «ON». After 1-3 seconds, turn
the key to «OFF» again and pull it out. In this way, a maximum of 5 keys can be
programmed by repeating the above procedure and keeping the indicated times.
FINAL STAGE
After extracting the key to be programmed «B», insert the «MASTER» key «A» again
and turn it to «ON» (perform this operation within the 10 seconds following the ex-
traction of the previous key). Leave it in this position for 1 to 3 seconds and return it
to «OFF».
20