Fisher-Price 79666 Manual page 6

Assembly
Front
Leg
Front
Support
6
#10 x 2
#10 Lock Nut - 2
Shown Actual Size
Lock Nut
Shown Actual Size
• While holding the front support in place, insert #10 x 2
screw through the outside of an armrest, front leg, front sup-
port and then out through the inside of the armrest.
• Fit a #10 lock nut into the hexagonal opening on the inside of
the armrest. Make sure the rounded side is facing out.
• Fully tighten the screw with a Phillips screwdriver. When
properly tightened, the end of the screw will be visible,
as shown above.
• Repeat this procedure to fasten the front support to the other
armrest with a #10 x 2 1 / " screw and #10 lock nut.
8
#10 Lock Nuts
Front
Leg
1
/ " Screw - 2
8
Rounded Side
End
of Screw
Visible
7
• Position the seat face down on a flat surface.
• Insert the seat tube through the a rectangular slot, the two
circular slots in the recline bar and then out through the other
rectangular slot.
8
1 / "
8
• Align the arrows on the seat tube with the arrows on the
recline bar.
6
Recline Bar
Rectangular Slots
Circular Slots
Seat Tube
Arrows on
Recline Bar
Arrows on
Seat Tube
Recline
Bar
Turn
Seat Tube
to Align
Arrows