Fisher-Price 79666 Manual page 5

Assembly
Armrest
Rear Legs
4
#10 x 2 1
#10 Lock Nut - 2
Shown Actual Size
Lock Nut
Shown Actual Size
• Insert a #10 x 2 1 / " screw through the outside of an armrest,
8
a rear leg and then out through the inside of the armrest.
• Fit a #10 lock nut into the hexagonal opening on the inside
of the armrest. Make sure the rounded side is facing out.
• Fully tighten the screw with a Phillips screwdriver. When
properly tightened, the end of the screw will be visible,
as shown above.
• Repeat this procedure to secure the other armrest with a
#10 x 2 1 / " screw and a #10 lock nut.
8
#10 Lock Nut
/ " Screw - 2
8
Rounded Side
End
of Screw
Visible
Front Support
Arrows
5
• Turn the leg assembly, as shown, so that the armrests point
toward you.
• Position the front support so that the arrows are pointing
toward you.
• Fit the ends of the front support up between the inside of the
armrests and the front legs.
5
Armrest
Front
Leg