Store It Cold CoolBot Manual page 29

3. Once your unit is out of the box, remove the 4 screws which fasten the cabinet at both sides
and back.
4. Slide the unit from the cabinet by gripping the base pan handle and pulling forward while
bracing the cabinet.
5. Carefully insert the A/C cabinet on the pre-cut hole from the inside of the cooler and slide
towards the outside until the top bracket of the cabinet touches the wall panel.
6. Ensure that the cabinet has a slight tilt downward towards the outside. Position the
cabinet so that the back is about ½" to 1" lower than the front. Use the holes at the bottom
of your A/C cabinet to screw in place to the edge of the precut hole on the wall panel. Your
cooler will not have a wood board as shown on the picture - it's not needed.
2020 © Store It Cold, LLC.
SUPPORT@STOREITCOLD.COM
29 Rev 2020-8A. All Rights Reserved.