Store It Cold CoolBot Manual page 19

WALK-IN COOLER INSTALLATION WITHOUT FLOOR OPTION
Your walk-in cooler panels, door, screeding, hardware, or outdoor package might differ in design
or looks from the ones shown in this manual and the installation video.
YOUR WALK-IN COOLER HAS BEEN PRE-ASSEMBLED AT THE FACTORY BEFORE CRATING TO ENSURE
PROPER FIT OF ALL PANELS AND TO ENSURE CORRECT DOOR OPERATION.
Having a successful cooler installation begins with HAVING AN EXISTING LEVEL SURFACE TO
ASSEMBLE YOUR COOLER. If the floor is slightly unlevel, it will be necessary to install shims under
the wall panels inside the vinyl screed until the wall panels are flush at the top.
NOTE: The vinyl screed has been pre-cut at the factory to match the layout of your cooler. If you
have to cut a piece of screeding you can use a miter saw or a hand saw. A piece numbered "0" may
be included as an extra piece.
1. Use a chalk line to mark the installation area to the dimensions of the walk-in as shown in
the drawing (Figure 1). Measure diagonally from corner to corner to be sure the floor vinyl
screed is square.
2. Apply TWO straight beads of silicone along the bottom of the vinyl screed (about an inch
away from the edges), then place the vinyl screed along the chalk lines. NOTE: Leave the
vinyl screed loose. DO NOT anchor to the floor.
3. Begin with two corner panels. Usually the left back corner is a good place to start. Stand the
wall panels inside the screed making sure they sit correctly (fully cradled in the screeding).
Make sure that the top of each wall adjacent panel is flush with each other and level. Use
the wrench to secure the wall panels together to start the wall. See Pic on next page.
2020 © Store It Cold, LLC.
IMPORTANT NOTE FOR COOLERS WITH NO FLOOR!
19
SUPPORT@STOREITCOLD.COM
Rev 2020-8A. All Rights Reserved.