Store It Cold CoolBot Manual page 20

4. If the wall panels have a stair-step appearance at the top, the floor is not level. In that
case, stop immediately and follow instructions on leveling the wall panels with shims for
slightly unlevel floors.
as you proceed. If they are not, loose the cam-locks, shim as necessary, adjust, and lock again
until they are level and flush at the top.
You can also install small shims as necessary under vinyl screed corners or across the panel
as needed, to ensure levelness of panels and walls across the top.
5. Select the next adjacent wall panel, going in a clockwise direction around the perimeter and
follow the same steps as above: Align, level, and lock to the adjacent wall panel. ALWAYS
double check for alignment making sure panel is flush and level on all sides and on top with
the adjacent panels.
2020 © Store It Cold, LLC.
Check for alignment to make sure the panels are flush with each other
20
SUPPORT@STOREITCOLD.COM
Rev 2020-8A. All Rights Reserved.