Related Manuals for Danfoss SFA 10
Summary of Contents for Danfoss SFA 10
- Page 1 Service guide / Repair kit installation Safety relief valves SFA 10, SFA 10H Fig. 1. Repair Kit Content 25 mm (1”) Fig. 2. Unseal SFA Fig. 3. Fixation/ Cap removal © Danfoss | DCS (ms) | 2020.11 AN352739267283en-000101 | 1...
- Page 2 6 mm 18 mm Fig. 4. Loosen locknut/ adjustment screw 35 mm Fig. 5. Unscrew inlet connector © Danfoss | DCS (ms) | 2020.11 AN352739267283en-000101 | 2...
- Page 3 Fig. 6. Cone-spindle removal Fig. 7. Cone-spindle replacement © Danfoss | DCS (ms) | 2020.11 AN352739267283en-000101 | 3...
- Page 4 Fig. 8. Insert Cone-spindle assembly Fig. 9. Reinstall inlet connector Calibration by authorized personel 30 Nm 22.1 ft lb Fig. 10. Reset adjustment screw Fig. 11. Calibration Fig. 12. Fasten lock nut © Danfoss | DCS (ms) | 2020.11 AN352739267283en-000101 | 4...
- Page 5 Repairing the SFA 10(H) The Cone and O-ring can be replaced using one the Danfoss SFA 10(H) repair kits. Observe that the repair kits are covering different set pressure ranges and that purchased repair kit matches the set pressure of the valve to be repaired.
- Page 6 1. Fasten lock nut to torque 30 Nm (22.1 ft lb) Fig. 13: Fasten cap 1. Replace O-ring 2. Fasten cap to torque 90 Nm (66.4 ft lb) Fig. 14: Reseal SFA 1. Reseal SFA © Danfoss | DCS (ms) | 2020.11 AN352739267283en-000101 | 6...
Need help?
Do you have a question about the SFA 10 and is the answer not in the manual?
Questions and answers