Table of Contents
Advertisement
JAW ASSEMBLY
When you receive your new PF Series vise, you will notice that the jaws do
not come attached. To install the vise jaws, follow the steps given below.
1.
Place both movable jaws on the rails of the vise, and slide the movable
jaws over the beaks of the nuts.
2.
Set the rear covers into their slots in the back of the movable jaws,
then use the button head screws to anchor the rear covers to the
movable jaws.
3.
Finish Securing the movable jaws by installing the spring plungers into
the rear covers. Tighten the spring plungers until they are snug, then
loosen them by 1/8 to 1/4 turn.
JAW TIGHTENING
SPRING PLUNGER
MOVABLE JAWS
JAW ASSEMBLY GUIDE
MOVABLE JAW
REAR COVER
JAW TIGHTENING
SPRING PLUNGER
5
Advertisement
Table of Contents
