Advertisement
8. Install the Ribbon Guide in the position from which the Ribbon Guide Shaft has been
removed.
① Insert the shaft of the Ribbon Guide into the hole at the front side and then its other
side into the hole at the opposite side.
① Insert the front side first.
Ribbon Guide
② Push up the unsecured side of the Ribbon Guide and then fit the hook into the
Ribbon Guide Shaft at the right-hand side.
Hook
Ribbon Guide Shaft
3.3 Attaching the Antenna Unit
1. Connect the Antenna Cable to the Antenna.
Antenna
attachment
position
Antenna
② Fit into the Ribbon Guide Shaft.
Antenna Cable
Antenna Unit
7/15
2. As shown in the figure below, hold the Antenna Unit so that the Antenna comes to the
lower side and the antenna attachment position comes to the right-hand side. Then fit the
Antenna Unit into the bottom surface of the Platen Holder.
Antenna Unit
Antenna Cable
3. Secure the lower side of the Earth Plate to the Platen Holder Frame together by using its
fixing screw.
Platen Holder Frame
4. Secure the upper side of the Earth Plate to Antenna Unit with the screw (SMW-3x6).
Tip: Align the four corners of the Antenna
Unit to the notches indicated by the
circles.
Platen Holder
Earth Plate
Screw (SMW-3x6)
8/15
Advertisement
