Ground Connector - Measurement Computing WebDAQ 316 User Manual

Push bu ons
Table 12. Push bu on specifica ons
Component
Power bu on
Func on bu on
Factory reset
bu on
Note 6. Refer to this circuit board image

Ground connector

Table 13. Ground connector specifica ons
Component
Ground connector
Label Descrip on
POWER W1 jumper installed (factory default)
W1 jumper removed
FUNC Dual func on:
CONFIG Restores network se ngs to factory default values; refer to the
RESET Factory default se ngs
for the loca on of the W1 jumper.
Label Descrip on
#6-32 Connector port for the #6-32 ground screw
WebDAQ 316 User's Guide
When device is off; press briefly to turn the device on
When device is on:
Press for ~1 second to shuts down the device; release
the bu on when the POWER LED blinks yellow
Press and hold ~4 seconds to force the device to power
off
(Note
Device will always be on if power is applied
Press for ~1 second to reboot the device; release the bu on
when the POWER LED blinks yellow
Ejects, or safely unmounts, all removable media for safe
removal from the device (default)
This func on is disabled when a job that uses external
media is running
The MEDIA LED is steady green when all media is
unmounted but s ll inserted in the device
Starts or stops an acquisi on; requires configura on via the
web interface
page 27
(Note 6)
6):
table for values.