Reversing The Access Door - Hatco FLAV-R-SAVOR Installation And Operating Manual

INSTALLATION

Reversing the Access Door

Doors are shipped from the factory mounted on the left side of
the cabinet, opening from the right. Use the following procedure
to reverse the door to open from the left.
1. Remove the top hinge screw. Make sure to locate and
save the top nylon washer.
2. Tip the door forward (away from cabinet) and lift gently to
clear the bottom hinge bracket. Remove the bottom nylon
washer.
3. Reinstall the hinge screw that was removed in the first
step.
4. Remove the bracket screws securing each hinge bracket
to the cabinet.
Screws moved
from right side
to plug holes.
5. Remove the hole plug screws from the right side of the
6. Rotate the door 180°.
7. Remove the hinge screw from the end of the door that is
8. Place the door assembly into the bottom hinge bracket
NOTE: Nylon washers must be installed between the door and
9. Tip/tilt the door assembly towards the cabinet and align
Reversing the Access Door (PFST-1X shown)
8
cabinet and install them into the left-side screw holes.
now the top.
while holding the thick nylon washer on the bottom hinge
screw.
the hinge brackets.
the door top with the hinge bracket. Reinstall the top hinge
screw through the hinge bracket, through the thin nylon
washer, and into the door top. Tighten securely.
Hinge Bracket
Bracket Screw
Thin
Nylon
Washer
Thick
Nylon
Hinge
Washer
Screw
English
Latched
Handle
Adjusting
Plate
Form No. PFSTM-0816