ABonAir AB405 Installation And User Manual page 9

General Safety Warnings
Always observe standard safety precautions during installation, operation and
maintenance of this product. Only qualified and authorized personnel should
carry out maintenance or repairs to the components of this system.
DANGER – ELECTRICAL SHOCK
The power supply unit contains dangerous voltage that can cause
electric shock. Disconnect the mains prior to any work on the
receiver. Local regulations must be adhered to when servicing
receivers.
Always disconnect the wiring at the power source before installing,
maintaining or modifying the system power wiring.
Outdoor Use: Wet conditions increase the potential for receiving an
electric shock when installing or using electrically powered
equipment.
Receivers supplied from the mains must be connected to grounded
outlets and in conformity with any local regulations.
CAUTION – COAX CABLE BENDING
Allow sufficient coax cable length to permit routing of patch cords or
pigtails without severe bends.
CAUTION – STATIC ELECTRICITY
Static electricity poses no risk of personal injury, but it can severely
damage essential parts of the system if not handled carefully.
Parts of the printed circuit board, as well as other parts of the receiver
are sensitive to electrostatic discharge.
Never touch the printed circuit board or annulated conductor surfaces
unless absolutely necessary.
If you must handle the printed circuit board or uninsulated conductor
surfaces, use ESD protective equipment, or first touch the receiver
chassis with your hand and then do not move your feet on the floor.
Never let your clothes touch printed circuit boards or uninsulated
conductor surfaces. Always store printed circuit boards in ESD-safe
bags.
Confidential – Version 1.0
Copyright © 2018 ABonAir Ltd.
General Safety Warnings
AB405 Installation and User Manual
9