Table of Contents
Advertisement
Operation
4
This chapter describes how to operate the AB405 system once it is installed.
4.1
Wireless Video
1
Connect the SDI or HDMI cables in both sides.
2
Connect power cables in both sides.
3
Turn on the Transmitter and Receiver.
4
The system will start working automatically after approximately 1
minute.
The Receiver LCD panel is a touch panel. You can touch it to manually
change the frequency used by the system
The main display is of the RSSI bar (Receive Signal Strength Indication)
which indicates the wireless reception quality. In most cases you should see
2-3 bars. In case you get 1 bar, this indicates that the system is at the edge of
reception and might have picture disturbances.
Confidential – Version 1.0
Copyright © 2018 ABonAir Ltd.
AB405 Installation and User Manual
Troubleshooting
19
Advertisement
Table of Contents
