Patch Parameters - Roland JU-06A Operation Manual

PATCH PARAMETERS

1. Press the SEQUENCER [EDIT] button to make it go dark.
2. Hold down the [MANUAL (16)] button and select a parameter by pressing one of the numeric buttons
shown in the following table.
3. Use the [VALUE] knob to edit the value.
4. Press the [MANUAL (16)] button once again to exit patch parameter editing.
BUTTON PARAMETER
[1] Portamento Switch Smoothly changes the pitch from the first-played note
[2] Portamento Time
[3] Bend Range
[4] Tempo Sync
[5] LFO Waveform
[6] LFO Key Trigger
VALUE/EXPLANATION
to the next-played note.
OFF, ON
Adjusts the time over which the portamento pitch change occurs.
0-255
Specifies the pitch bend range in semitone units.
OFF, 1-24
Synchronizes the LFO's RATE or the DELAY's TIME to the tempo.
OFF, ON
Switches the LFO waveform.
Tri (Triangle wave), Sqr (Square wave),
SA1 (Sawtooth wave1), SA2 (Sawtooth wave2),
Sin (Sine wave), rd1 (Random wave1),
rd2 (Random wave2)
Specifies whether the LFO cycle is aligned with the timing at which you
play the key (on) or is not aligned (off ).
OFF, On
* Saved as a patch setting.