Setting Angle Of Air Flow; Setting Vertical Angle Of Air Flow; Setting Horizontal Angle Of Air Flow; Sleep Operation - Bosch Climate 5000 User Manual

6 Unit Specifications and Features
1.6.

Setting Angle of Air Flow

1.6.1. Setting vertical angle of air flow

While the unit is on, use the SWING/DIRECT button to set the direction
(vertical angle) of airflow.
1 Press the SWING/DIRECT button once to activate the louver. Each
time you press the button, it will adjust the louvre by 6°. Press the
button until the direction you prefer is reached.
2 To make the louvre swing up and down continuously, press and hold
the SWING/DIRECT button for 3 seconds. Press it again to stop the
automatic function.

1.6.2. Setting horizontal angle of air flow

The horizontal angle of the airflow must be set manually. Grip the
deflector rod (See Fig. 1-2) and manually adjust it to your preferred
direction. For some units, the horizontal angle of the airflow can be set by
remote control, please refer to the Remote Control Manual.
NOTE ON LOUVER ANGLES
When using COOL or DRY mode, do not set louvre at too vertical an angle
for long periods of time. This can cause water to condense on the louvre
blade, which will drop on your floor or furnishings. (See Fig. 1-1).
When using COOL or HEAT mode, setting the louvre at too vertical an
angle can reduce the performance of the unit due to restricted air flow.
Do not move louvre by hand. This will cause the louvre to become out of
sync. If this occurs, turn off the unit and unplug it for a few seconds, then
restart the unit. This will reset the louvre.
Do not keep louvre at too vertical an angle for long periods of time.
This can cause water condensation to drip on your furnishings.
Bosch Climate 5000
Figure 1-1
CAUTION
Do not keep louvre at too vertical an angle for long periods of time.
This can cause the water condensation to drip on your furnishings.
Deflector rod
1.7.

Sleep Operation

The SLEEP function is used to decrease energy use while you sleep (by
doing so it allows you to sleep in a comfortable ambient temperature).
This function can only be activated via the remote control.
Press the SLEEP button when you are ready to go to sleep. When in
COOL mode, the unit will increase the temperature by 1°C (2°F) after
1 hour, and will increase an additional 1°C (2°F) after another hour.
When in HEAT mode, the unit will decrease the temperature by 1°C (2°F)
after 1 hour, and will decrease an additional 1°C (2°F) after another hour.
It will hold the new temperature for 5 hours, then the unit will turn off
automatically.
The SLEEP function is not available in FAN or DRY mode.
SLEEP Operation
Set
temperature
Saving energy during sleep
CAUTION
Figure 1-2
NOTE
7 hours
timer off
Figure 1-3
6 720 866 141 (2016/07)