Connecting The Sdi Signals - Sony TRIMASTER PVM-X2400 Operating Instructions Manual

The output audio signal can be changed under
"Audio Preset" (page 27) in the "User Preset
Setting" menu.
 ENHANCED MONITOR OUT connector
Used for future expansion. It is currently
unavailable.
 SDI OUT (SDI output) connectors (BNC)
Output connectors for serial digital signals.
The signal input to the SDI IN connector
corresponding to the  to  is output.
Notes
SDI output is not activated when the unit is

turned off or in sleep mode.
If a 12G-SDI or 6G-SDI signal is output from the

SDI OUT connector, a 12G-SDI cable (L-5.5CUHD
manufactured by Canare Electric Co., Ltd. or an
equivalent) is recommended.
 SDI IN (SDI input) connectors (BNC)
Input connectors for serial digital signals.
For details, see "Connecting the SDI Signals"
(page 14).
Note
If a 12G-SDI or 6G-SDI signal is input to the SDI IN
connector, a 12G-SDI cable (L-5.5CUHD

Connecting the SDI Signals

The following signals can be input to the SDI IN connectors of this unit.
Input signal
Single Link 3G/HD-SDI
12G/6G-SDI
Dual Link 3G/HD-SDI
Quad Link
(2-sample interleave 3G/HD-SDI
division)
Quad Link
3G/HD-SDI
(Square division)
-
-
3G/HD-SDI Link 1
3G/HD-SDI Link 2
3G/HD-SDI Link 1
3G/HD-SDI Link 2
3G-SDI Link 1
3G-SDI Link 2
3G-SDI Link 3
3G-SDI Link 4
Mapping signal of Sub image 1 (upper-left screen)
Mapping signal of Sub image 2 (upper-right screen)
Mapping signal of Sub image 3 (lower-left screen)
Mapping signal of Sub image 4 (lower-right screen)
14
manufactured by Canare Electric Co., Ltd. or an
equivalent) is recommended.

DC IN 22 to 32 V (DC power input)
connector
Connect to a DC 22 V to 32 V DC power supply.
Pin assignment (Rear of monitor)
Pin number Functions
1 – (GND)
2 + (DC 22 V to 32 V)
3 NC
 AC IN socket
Connect the supplied AC power cord.
 Main power switch
Press  to turn on the unit.
Note
If a no input-signal state continues for 60
minutes, the monitor is automatically turned off
by the auto power-off function. To turn on the
monitor, press the  (Power) switch. To change
the settings, see "Auto Power Down" (page 38) of
"System Setting" in the "System" menu.
Connector
1 to 4
1, 3
Maximum
4 channels
2 channels
1
2
2 channels
3
4
1
2
1 channel
3
4
1
2
1 channel
3
4