Vrrp Vrid Monitor - H3C S9500 Series Command Manual

Command Manual – VRRP
H3C S9500 Series Routing Switches
By default, the fast switch function for a virtual router in backup state is disabled.
Note:
After the vrrp vrid fast-switch command is executed, the vrrp vrid virtual-router-id
preempt-mode timer command does not take effect.
Examples
# Enable the fast switch function on VLAN-interface 30.
<H3C> system-view
[H3C] interface vlan-interface 30
[H3C-Vlan-interface30] vrrp vrid 1 fast-switch

1.1.13 vrrp vrid monitor

Syntax
vrrp vrid virtual-router-id monitor { interface interface-type interface-number |
link-aggregation group group-id }
undo vrrp vrid virtual-router-id monitor
View
VLAN interface view
Parameters
virtual-router-id: VRRP virtual router ID, in the range 1 to 255.
interface interface-type interface-number: Specifies an interface.
group group-id: Specifies an aggregation group ID, in the range 1 to 31.
Description
Use the vrrp vrid monitor command to enable the virtual router to monitor the
specified link.
Use the undo vrrp vrid monitor command to disable the function.
By default, the link monitoring function is disabled.
Chapter 1 VRRP Configuration Commands
1-12