For l4330 fst, gst, hst, l4630 fst, gst, hst and l5030 gst, hst (6 pages)
Summary of Contents for Kubota AP-SR2672
Page 1
Table of Contents Powered Rakes AP-SR2672, & AP-SR2690 for Skid Steer 37786 321-004MK Operator’s Manual Read the Operator’s Manual entirely. When you see this symbol, the subsequent instructions and warnings are serious - follow without exception. Your life and the lives of others depend on it! Cover photo may show optional equipment not supplied with standard unit.
Machine Height Machine Length Machine Width Machine Weight Delivery Date First Operation Accessories Dealer Contact Information Name: Street: City/State: Telephone: Email: California Proposition 65 WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov AP-SR2672, & AP-SR2690 for Skid Steer Powered Rakes 321-004MK 4/10/19...
Page 3
Copyright 2019 All rights Reserved Kubota provides this publication “as is” without warranty of any kind, either expressed or implied. While every precaution has been taken in the preparation of this manual, Kubota assumes no responsibility for errors or omissions. Neither is any liability assumed for damages resulting from the use of the information contained herein. Kubota reserves the right to revise and improve its products as it sees fit.
Page 4
Download the appropriate App on your Parts Manual QR Locator on smart phone, open the App, point your this page for detailed phone on the QR code and take a picture. instructions. AP-SR2672, & AP-SR2690 for Skid Steer Powered Rakes 321-004MK 4/10/19...
Important Safety Information Important Safety Information Listed below are common practices that may or may not be applicable to the products described in this manual. Safety at All Times Look for the Safety Alert Symbol Careful operation is your best The SAFETY ALERT SYMBOL indicates there is a assurance against an accident.
Page 6
Lower attachment to the ground and Replace parts on this attachment above recommended pressures follow all shutdown procedures with genuine Kubota parts only. Do shown in the Operator’s Manual. before leaving the operator’s seat to not alter this attachment in a way ...
Page 7
Use Seat Belt and ROPS Keep Riders Off Lights and Devices Machinery Kubota recommends the use of a CAB or roll-over-protective- Slow moving tractors, skid steers, Never carry riders on skid steer structures (ROPS) and seat belt and self-propelled machines can or attachment.
Important Safety Information Listed below are common practices that may or may not be applicable to the products described in this manual. Be aware of and follow OSHA If possible, change into disposable Avoid crystalline Silica or washable work clothes at the (or other local, State, or Federal) (quartz) Dust guidelines for exposure to airborne...
Page 9
Important Safety Information This page left blank intentionally. 4/10/19...
Some new equipment installed during repair requires with a similar type of straight edge. safety labels to be affixed to the replaced component as 838-106C 37787 Warning: General Safety 24534 838-107C Warning: Thrown Object Hazard AP-SR2672, & AP-SR2690 for Skid Steer Powered Rakes 321-004MK 4/10/19...
Page 11
Table of Contents Important Safety Information 37788 818-339C Warning: High Pressure Fluid Hazard 37788 818-798C Warning: Pinching Hazard 838-111C Danger: Moving Parts 37786 4/10/19 AP-SR2672, & AP-SR2690 for Skid Steer Powered Rakes 321-004MK...
Read this manual Your Kubota dealer wants you to be satisfied with your and follow the recommendations to help ensure safe new attachment. If for any reason you do not understand and efficient operation.
Consult your 2. Tighten nuts to correct torque. By-Pass Valve Hydraulic Hoses Must Arch Up Hydraulic Motor 37789 Gauge Wheel Assembly Figure 1-1 AP-SR2672, & AP-SR2690 for Skid Steer Powered Rakes 321-004MK 4/10/19...
Page 15
2. Secure right-hand side plate (#3) to the rake frame with linchpin (#4). 3. Repeat steps 1 through 2 for left-hand end plate. 24535 SR2672 Side Plate Assembly (Right-Hand Side Shown) Figure 1-2 4/10/19 AP-SR2672, & AP-SR2690 for Skid Steer Powered Rakes 321-004MK...
To avoid serious injury or death: (Optional)” below. • Make sure hydraulic hoses are properly routed without twists to prevent becoming stretched, pinched, or kinked. A damaged hose can burst and leak hydraulic fluid. AP-SR2672, & AP-SR2690 for Skid Steer Powered Rakes 321-004MK 4/10/19...
Page 17
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - Refer to “Control Harness With 2 Eyelets” on page 15. Kubota offers two controllers for operating the Powered Rake when attached to a Kubota compact track loader or skid steer loader.
Page 18
323-096A . . .SWITCH & WIRE HARNESS DTP PLUG This switch and wire harness is designed for attaching the Powered Rake to a Kubota CTL when a 14 pin Deutsch plug is not available and 2 pin Deutsch plug located behind the driver’s seat is available. The 2 push button control switch (#10) can be placed approximately 9 ft.
9. Continue with “Operational Check” on this page. NOTE: Additional zip ties may be needed to properly secure all wiring harness. Customer to supply and locate all additional zip ties. 4/10/19 AP-SR2672, & AP-SR2690 for Skid Steer Powered Rakes 321-004MK...
Always follow “Tractor Shutdown Procedure” provided in this manual before dismounting the tractor. IMPORTANT: Avoid catching the hydraulic hoses on brush, post, stumps, and other protrusions that could damage and/or break them. AP-SR2672, & AP-SR2690 for Skid Steer Powered Rakes 321-004MK 4/10/19...
Page 21
Always drive up a ramp with heavy end uphill. • Engage skid steer park brake and remove ignition switch key once it is loaded. • Secure Skid Steer Loader and attachment using tie downs and chains. 4/10/19 AP-SR2672, & AP-SR2690 for Skid Steer Powered Rakes 321-004MK...
Page 22
Adjusting the blade up allows more clods, rocks, and debris to pass over the roller and produces a coarser soil finish. AP-SR2672, & AP-SR2690 for Skid Steer Powered Rakes 321-004MK 4/10/19...
(A) and sliding material control blade (B) up or down to desired height. 30935 24534 Depth Adjustment Front Material Control Blade Adjustment Figure 3-1 Figure 3-3 4/10/19 AP-SR2672, & AP-SR2690 for Skid Steer Powered Rakes 321-004MK...
(#2) and secure with lock washers (#9) and from the chain case. 1/4"-20 x 5/8" GR5 hex bolts (#4). Torque hex bolts to the correct torque. 37790 Drive Chain Adjustment Figure 3-4 AP-SR2672, & AP-SR2690 for Skid Steer Powered Rakes 321-004MK 4/10/19...
Page 25
3. Repeat steps 1-2 for left-hand side plate. 24535 24536 21106 Working Position of Side Plates (Right-Hand Side Shown) Storage Position of Side Plates (Right-Hand Side Shown) Figure 3-5 Figure 3-6 4/10/19 AP-SR2672, & AP-SR2690 for Skid Steer Powered Rakes 321-004MK...
9. Store Powered Rake on a level surface in a clean, dry place. Inside storage will reduce maintenance and make for a longer rake life. 37788 Gauge Wheel U-Bolts Figure 4-3 4/10/19 AP-SR2672, & AP-SR2690 for Skid Steer Powered Rakes 321-004MK...
Page 28
Pivot Grease pivot point every 25 hours Two grease zerks Type of Lubrication: Multi-Purpose Grease Quantity: Add grease until grease begin to emerge from either top or bottom bushings. 37791 AP-SR2672, & AP-SR2690 for Skid Steer Powered Rakes 321-004MK 4/10/19...
Page 29
Type of Lubrication: Multi-Purpose Grease (Remove Skid Shoe to grease) Quantity: Add grease until grease begin to emerge from either side of the axle. Remove Skid Shoe To Grease 24533 4/10/19 AP-SR2672, & AP-SR2690 for Skid Steer Powered Rakes 321-004MK...
Add gear lube until it escapes from lower plug hole. 63 1/2" 72 1/2" (1.61 m) (1.84 m) 42 3/4" (1.09 m) SR2690 = 100 3/4" (2.56 m) SR2672 = 82 3/4" (2.10 m) 37793 AP-SR2672, & AP-SR2690 for Skid Steer Powered Rakes 321-004MK 4/10/19...
Skid shoes protect larger and vital parts of the unit. As they wear due to soil contact, they can easily be replaced. Universal fit Universal fit with new and late model skid steer units. 4/10/19 AP-SR2672, & AP-SR2690 for Skid Steer Powered Rakes 321-004MK...
Increase roller speed if roller is turning slow. Decrease roller speed if roller is turning fast. Move wire on top solenoid to bottom solenoid and wire on bottom solenoid to top Roller angling opposite of switch solenoid. AP-SR2672, & AP-SR2690 for Skid Steer Powered Rakes 321-004MK 4/10/19...
2970 2190 4820 3560 Torque tolerance + 0%, -15% of torquing values. Unless otherwise specified use torque values listed above. Tire Inflation Chart Tire Size 16.5 x 6.5 2- Ply 4/10/19 AP-SR2672, & AP-SR2690 for Skid Steer Powered Rakes 321-004MK...
Page 34
IMPORTANT: The Online Warranty Registration should be completed by the dealer at the time of purchase. This information is necessary to provide you with quality customer service. Model Number ____________________ Serial Number ____________________ AP-SR2672, & AP-SR2690 for Skid Steer Powered Rakes 321-004MK 4/10/19...
Page 35
Kubota used reasonable efforts to set forth and include accurate and up to date information in this publication. Kubota disclaims all representations and warranties, whether express or implied, including, but not limited to, warranties of merchantability...
Page 36
1175 S. Guild Ave., Lodi, CA 95240 Telephone: (209) 334-9910 Central Division: 14855 FAA Blvd., Fort Worth, TX 76155 Telephone: (817) 571-0900 Northern Division: 6300 at One Kubota Way, Groveport, OH 43125 Telephone: (614) 835-1100 Southeast Division: 1025 Northbrook Parkway, Suwanee, GA 30024 Telephone: (770) 995-8855...
Need help?
Do you have a question about the AP-SR2672 and is the answer not in the manual?
Questions and answers