B.Well PRO-110 Instructions For Use Manual page 19

Instruction for Use
Guidance and manufacturer's declaration - electromagnetic emissions
The PRO-110/PRO-115 is intended for use in the electromagnetic environment specified
below. The customer or the user of the PRO-110/PRO-115 should assure that it is used in
such an environment
Immunity Test
Electrostatic
discharge (ESD)
IEC 61000-4-2
Electrical fast
transient/burst
IEC 61000-4-4
Surge
IEC 61000-4-5
Voltage
dips, short
interruptions
and voltage
variations on
power supply
input lines
IEC 61000-4-11
M_PRO-110_PRO-115_EN_RO_BG_2916.indd 19
IEC 60601 Compliance
level
Test level
±6 kV contact ±6 kV contact
±8 kV air
±8 kV air
±2 kV for power ±2 kV for power
supply lines supply lines
±1 kV for input/
output lines
±1 kV line(s) to ±1 kV line(s) to
line(s) line(s)
±2 kV line(s) to
earth
<5% UT <5% UT
(>95% dip in UT) (>95% dip in UT)
for 0.5 cycle for 0.5 cycle
40% UT 40% UT
(60% dip in UT) (60% dip in UT)
for 5 cycle for 5 cycle
70% UT 70% UT
(30% dip in UT) (30% dip in UT)
for 25 cycle for 25 cycle
<5% UT <5% UT
(>95% dip in UT) (>95% dip in UT)
for 5s for 5s
PRO-110 / PRO-115
Electromagnetic environment
- guidance
Floors should be wood,
concrete or ceramic tile.
If floors are covered with
synthetic material, the relative
humidity should be at least
30 %
Mains power quality should be
that of a typical commercial or
hospital environment.
The electrical fast transient
burst (EFT) is generated by
the switching of inductive
loads. Separation between the
equipment and other loads
shall be considered before
installation. Mains filter is
required, if necessary.
Mains power quality should be
that of a typical commercial or
hospital environment.
Mains power quality should be
that of a typical commercial
or hospital environment. If
the user of the PRO-110/
PRO-115 requires continued
operation during power
mains interruptions, it is
recommended the PRO-110/
PRO-115 be powered from an
uninterruptible power supply
or a battery.
19
21.07.2016 11:39:03