Replacement Of The Air Filter; Cleaning, Maintenance And Storage; Cleaning The Device And Accessories - B.Well PRO-110 Instructions For Use Manual

Instruction for Use

8. REPLACEMENT OF THE AIR FILTER

The Air filter must be replaced in case of damage or severe contamination.
In normal usage conditions, the air filter must be replaced approximately after 500 work-
ing hours or after each year.
It is recommended periodically checking the air filter (10 – 12 treatments) and, if the filter
shows a grey or brown color or is wet, replace it.
1.
2. Extract the air filter bladder from the device by pulling it up
3. Extract the filter and replace it with a new one (for example with the help of tweezers)
4. Set the air filter bladder on its place
5. Turn the cover clockwise to fix it (only for the PRO-115)
cotton, may lead to device damage. Use original filters only.
•
•
•
•

9. CLEANING, MAINTENANCE AND STORAGE

Cleaning the device and the accessories
The cleaning of the device must be carried out by using a soft and dry cloth and non-
abrasive cleansers.
are not in contact with liquids and that the power plug is disconnected.
Follow carefully the cleaning and disinfection instructions of the accessories as they are
very important for the device performances and the therapy success.
necessary to clean all the accessories according to the following instructions:
•
•
•
•
Sterilization:
•
•
12
M_PRO-110_PRO-115_EN_RO_BG_2916.indd 12
Turn the air filter cover counterclockwise (only for PRO-115)
WARNING! The use of dirty filter or filter made of another material, for example,
Do not use the device without filter.
Do not try to clean the filter for reusing it. If the filter is wet replace it.
The air filter shall not be serviced or maintained while in use with a patient.
To avoid the air filter cover obstruction clean it regularly.
WARNING! Air filters cannot be cleaned or washed.
ATTENTION! During cleaning operations, make sure the internal parts of the unit
ATTENTION! Before first using of the device and after each treatment it is
Disassemble the nebulizer by turning counterclockwise the top and remove the medi-
cine conduction cone.
Wash the components of the disassembled nebulizer, the mouthpiece and nosepiece
by using tap water; dip in boiling water for 5 minutes.
Reassemble the nebulizer components and connect it to the air-outlet, switch the
device on and let it work for 10-15 minutes or put on the clean paper towel for drying
on the air.
The masks and air tube must be washed with warm water. Does neither boil nor
autoclave the air tube and masks!
Use cold disinfecting liquids following the instructions of the sterilization liquids'
manufacturer.
Wash your hands and take the components out from disinfection solution, wash the
PRO-110 / PRO-115
21.07.2016 11:39:03
co
• D
w
ca
Cauti
of dev
presc
Open
techn
Note:
The n
defor
medic
Use o
Main
If you
• do
di
• do
Opera
Utiliza
with t
10. D
The u
dome
For di