Table of Contents
Advertisement
Follow these guidelines for cleaning the kiosk:
•
•
Clean the Touch Panel and Scanner Window
To keep the kiosk touch panel and scanning window in good condition, you may
need to clean them as often as needed. The touch panel and scanner window
withstands application of the following cleaning agents when applied to a clean
soft cloth and removed immediately with a dry soft cloth.
•
•
•
To clean,
1. Turn off the printer switch, remove the power cables.
2. Press and hold the tablet power button, tap Power off.
Note: Make sure that the cleaning solutions do not come in contact with power cables.
3. Dip a clean cloth towel in the cleaning agent and wring out the excess.
4. Wipe off the touch panel and scanner window. Do not allow any abrasive
5. Wipe dry.
6. Let it air dry completely before using the kiosk again.
Clean the Printhead
Cleaning the printhead on a regular basis is important for the life of the printhead
and for the print quality. Clean the printhead each time you replace the media.
Follow this procedure to clean the printhead using the cleaning card. If you need to
clean additional residue from the platen roller or tear bar, use a cotton swab
moistened with isopropyl alcohol.
Caution: Never use any sharp tools for removing stuck labels. The
Warning: The printhead/motor may be hot. Allow the printhead/motor to
1. Turn the kiosk off and disconnect the kiosk from power.
2. Open the printer lid and remove the media.
3. Insert most of the cleaning card under the printhead, and then lower the
40
Always remove the power cord before cleaning.
Never spray the kiosk with water. Protect it from water when cleaning the
premises.
Acetic acid, 10% in water
Ethyl alcohol, 10% in water
Mild soap solutions
material to touch these surfaces.
printhead and rollers are delicate.
cool.
printhead.
PC43K User Guide
Advertisement
Table of Contents
