Connecting To Power Supply - Stihl BGE 61 Instruction Manual

English
4
5
Position the intake screen (3) on the
N
intake opening.
Line up the arrows (4).
N
Rotate the intake screen (3) in
N
direction of arrow until the lug (5)
engages audibly on the blower
housing.
Lock button (arrow) must engage in
position.
10

Connecting to Power Supply

The voltage and frequency of the
machine (see rating plate) must match
the voltage and frequency of the power
connection.
The minimum fuse protection of the
power connection must comply with the
specifications – see "Specifications".
The machine must be connected to the
power supply via an earth-leakage
circuit breaker to disconnect the power
supply if the differential current to earth
exceeds 30 mA.
The power connection must correspond
to IEC 60364 and relevant national
regulations.
Extension Cords
Make sure your electrical cord set is in
good condition and suitable for outdoor
use. When using an extension cord, be
sure to use one heavy enough to carry
the current your product will draw. An
undersized extension cord may cause a
drop in line voltage resulting in loss of
power and overheating. The table below
shows the correct size (AWG) to use for
your machine (Cord types SJW or
SJTW) depending on cord length and
nameplate ampere rating. If in doubt,
use the next heavier gauge. The smaller
the gauge number, the heavier the cord.
Cord length (ft) Wire gage (AWG)
50 16
100 14
150 12
Appropriate extension cords are
available in special stores for electrical
equipment or from your STIHL dealer.
Strain relief (cord retainer)
The strain relief protects the appliance
cord against damage.
2
1
Insert the plug (1) into the extension
N
cord coupling (2).
3
5
4
Make a loop in the extension cord.
N
Pass the loop (3) through the
N
opening (4).
Slip the loop over the hook (5) and
N
pull it tight.
Connecting to Wall Outlet
Make sure your machine is switched off
before you connect it to the power
supply – see "Switching Off".
BGE 61, BGE 71