Interface Configuration; Deployment Of The Services; Table 2-17 Half Yearly Check Of Interface Configuration; Table 2-18 Half Yearly Check Of Deployment Of The Services - Nortel Secure Router 8000 Series Routine Maintenance

2 Routine maintenance items

2.6.1 Interface configuration

Table 2-17 Half yearly check of interface configuration

Ensure the following conditions are met:
Item
Interface
clock
Ethernet
interface
configuration
IP address
MTU

2.6.2 Deployment of the services

Table 2-18 Half yearly check of deployment of the services

Ensure the following conditions are met:
Item
Static route
CIDR
2-12
Action
Run the display
interface command
Run the display
interface Ethernet and
the display interface
gigabitethernet
commands
Run the display
interface pos command
Run the display
interface command
Action
Run the display ip
routing-table protocol
static command
Run the display ip
routing-table protocol
static command
Nortel Networks Inc.
Nortel Secure Router 8000 Series
Remarks
When two routers are directly connected
back-to-back, set the master clock mode for
both of them or set one as the master clock
and the other set as the slave clock.
If you adopt WDM between the routers, set
both of them in the master clock mode.
If you adopt SDH or SONET system with
source between both the routers, set both of
them in the slave master clock mode to
synchronize with the SDH or SONET
system.
Configure clocks to only those interfaces
with PPP.
Interface configurations that include rate and
duplex mode are the same at the both ends.
For the IP addresses of the point-to-point
interfaces, set the subnet mask to 30 bits.
The MTU of local interface is the same as that
of the peer interface.
Remarks
There is no redundant static route.
Combine the routing entries through CIDR.
Do not create useless route and redundant
route.
Routine Maintenance
Issue 5.3 (
19 May 2009
)