Table of Contents
Advertisement
Before adjustments, always turn off the motor switch and check to make sure that the motor is in stop
mode.
Warning
(9) Adjusting moving blade carrier guide (upper)
The fixed blade body simultaneously moves to the left
with the moving blade body and stops as it touches the
stopper for the fixed blade carrier.
A. Loosen the screws (27) (2 each).
B. When the moving blade body stops as described
above, adjust the clearance between the moving blade
body ③ and the moving blade carrier guide (upper)
(28) between 0.05 and 0.1mm.
C. Tighten the screws (27).
③
0.05mm~
0.1mm
(28)
(28)
③
(27)
[ Figure 93 ]
53
Advertisement
Table of Contents
