Table of Contents
Advertisement
Before adjustments, always turn off the motor switch and check to make sure that the motor is in stop
mode.
Warning
(6) Position of fixed blade body
The fixed blade body ⒃ simultaneously moves to the
left with the moving fixed body ③ and stops after
contacting the stopper for fixed blade body ⒔. At this
point, the fixed blade will slide under the needle plate
and begin to move.
Do not force the fixed blade body ⒃
to the left for the clamp spring
pressure can touch the looper.
Warning
A. Unfasten the screw ⒕.
B. Set a clearance of 1mm between the left end tip of the
thread trimming base ⒖ and the left end tip of the
stopper for fixed blade body ⒔.
C. Adjust the screw ⒕ afterwards.
50
③
⒃
⒔
⒕
1mm
⒖
[ Figure 88 ]
Advertisement
Table of Contents
