Storing Dab Services In Memory; Tuning In To A Preset Dab Service - JVC KD-SH9101 Instructions Manual

Storing DAB services in
memory
You can preset up to 6 DAB services in each
DAB band (DAB1, DAB2, and DAB3) manually.
1
Select the DAB tuner.
Each time you press the button,
the source changes as described
SRC
on page 7. When you select a
source, the power automatically
comes on.
2
Select the DAB band (DAB1, DAB2,
or DAB3).
1 Press and hold SRC for more
SRC
2 Within about 5 seconds (wile
DAB1
DAB3
DAB2
3
Tune in to an ensemble you want.
4
Select a service of the ensemble you
want to listen to.
Press 5 (up) to select the next
service.
Press ∞ (down) to select the
previous service.
64
than 1 second.
The band indication on the
display starts flashing.
the band indication is
flashing), press SRC again.
Each time you press the
button, the band changes.
5
Press and hold the number button
(in this example, 1) you want to store
the selected service into for more
than 2 seconds.
1
The display pattern automatically changes
to the initial display pattern and the preset
number flashes (then the previous display
pattern resumes).
6
Repeat the above procedure to store
other DAB services into other preset
numbers.
Notes:
• You can only preset primary DAB services. If you
store a secondary service, its primary service will
be stored instead.
• A previously preset DAB service is erased when a
new DAB service is stored in the same preset
number.
Tuning in to a preset DAB
service
You can easily tune in to a preset DAB service.
Remember that you must store services first. If
you have not stored them yet, "Storing DAB
services in memory."
1
Select the DAB tuner.
Each time you press the button,
SRC
the source changes as described
on page 7. When you select a
source, the power automatically
comes on.