Storing Stations In Memory - JVC KD-SH9101 Instructions Manual

When an FM stereo broadcast is hard to
receive:
Set the FM reception mode to "Mono On."
1
Press MODE (M) while listening to
an FM stereo broadcast.
"Mode" appears on the display, and
the number buttons start flashing.
2
Press number button 1, while "Mode" is still
on the display.
Each time you press the button, "Mono On"
and "Mono Off" alternately appears.
1 2
The display returns to the source indication
screen.
If the sound quality decreases and the
stereo effect is lost while listening to an
FM station
In some areas, adjacent stations may
interfere with each other. If this interference
occurs, this unit can automatically reduce this
interference noise (initial factory setting).
However, in this case, the sound quality will
be degraded and the stereo effect will be also
lost.
If you do not want to degrade the sound
quality and to lose the stereo effect, rather
than to eliminate the interference noise, see
"To change the FM tuner selectivity—IF
Filter" on page 49.
12
MODE
M
3 4 5
After about
5 seconds
MO indicator appears

Storing stations in memory

You can use one of the following two methods to
store broadcasting stations in memory.
• Automatic preset of FM stations: SSM (Strong-
station Sequential Memory)
• Manual preset of both FM and AM stations
FM station automatic preset: SSM
You can preset 6 local FM stations in each FM band
(FM1, FM2 and FM3).
1
Select the FM band (FM1 – 3) you want
to store FM stations into.
SRC
6
AM
FM1
FM3 FM2
2
Start SSM.
MODE
M
5
Local FM stations with the strongest signals are
searched and stored automatically in the band
number you have selected (FM1, FM2 or FM3).
These stations are preset in the number buttons —
No.1 (lowest frequency) to No.6 (highest
frequency).
When automatic preset is over, the station stored
in number button 1 will be automatically tuned in.
1 Press SRC (source)
repeatedly to select the tuner.
2 Press and hold SRC for more
than 1 second.
The band indication on the
display starts flashing.
3 Within about 5 seconds (while
the band indication is
flashing), press SRC again.
Each time you press the
button, the band changes.
1 Press MODE (M).
"Mode" appears on the
display, and the number
buttons start flashing.
2 Press and hold number
button 5 until "– SSM –"
appears.