JVC KD-SH9101 Instructions Manual page 38

To make sounds natural—BBE:
BBE Digital* is a new digital processing
method to restore the brilliance and clarity of
the original live sound in recording,
broadcasts, etc.
When a speaker reproduces sound, it
introduces frequency-dependent phase
shifting, causing high-frequency sounds to
take longer to reach the ear than low
frequency sounds. BBE Digital adjusts the
phase relationship between the low, mid and
high frequencies by adding a progressively
longer delay time to the low and mid
frequencies, so that all frequencies reach
the listener's ears at the proper time.
Select the effect level.
ATT
BBE Off
(Canceled)
As the number gets higher, the effect level
becomes stronger.
When shipped from the factory, the effect
level is set to "BBE Off" (BBE Digital is
canceled).
Note:
If "V.CANCEL" is selected for the DSP mode, you
cannot change the BBE level.
* Manufactured under license from BBE Sound,
Inc.
Licensed by BBE Sound , Inc. under USP4638258
and 4482866. BBE and BBE symbol are
registered trademarks of BBE Sound, Inc.
38
To increase the level.
To decrease the level.
BBE 1 BBE 2 BBE 3
To adjust the input level of each source
—Vol Adj:
This setting is required for each source
except FM. Before making an adjustment,
select an appropriate source for which you
want to make an adjustment.
Once you have made an adjustment, it is
memorized, and you will not need to adjust
the volume level each time you change the
source.
Adjust to match the input level to the FM
sound level.
ATT
To decrease the level.
If the (INPUT OVER) indicator appears
on the display, and sounds are distorted
The input level through the external component (LINE
IN) is set at a high level (more than 1.5 Vrms).
If this happens, adjust the output level on the
connected component so that the
(INPUT OVER) indicator will not appear.
(INPUT OVER) indicator
To increase the level.