Starting / Stopping The Engine - Stihl RL-MM Instruction Manual

English
1
3
The axle (1) must be below the shaft (2).
Direction of rotation (3) of MultiTool.
Adjusting Position of Gearbox
Loosen clamp screws on gearbox.
N
Turn the gearbox through 180°.
N
Line up the gearbox in the correct
N
position.
Tighten down the two clamp screws
N
on the gearbox in the following
sequence:
Tighten the first screw moderately.
–
Tighten the second screw
–
moderately.
Tighten down first screw firmly.
–
Tighten down second screw firmly.
–
8
2
NOTICE
It must not be possible to rotate the
gearbox on the drive tube.
Mounting the MultiTool
Arrange the blades in the order they
N
will be fitted on the axle, noting the
following points:
Left-hand and right-hand blades are
different. The direction of rotation is
marked with arrows on the gearbox and
blades. Make sure the arrows point in
the same direction.
5
Rotate the inner right-hand
N
blade (4) on the axle until it can be
pushed into position – check the
direction of rotation again (arrows).
The hub of the inner blade is larger than
that of the outer blade.
Rotate the outer right-hand
N
blade (5) on the axle until it can be
pushed into position – check the
direction of rotation again (arrows).
Insert and engage the hitch pin (6)
N
in the hole in the axle – fold the hitch
pin flat against the blade.
Use the same procedure to mount
N
the blades on the left-hand side.
6
4
Starting / Stopping the
Engine
Starting the Engine
Always follow the starting procedure
described in the MultiEngine instruction
manual.
Secure the handlebar in the normal
N
operating position.
Retract the wheels, if fitted – see
N
chapter on "Wheels" in MultiEngine
instruction manual.
Retract the spur, if fitted.
N
RL-MM