Pruning; Cutting Logs Under Tension - Stihl MSE 141 C Instruction Manual

7 Proper Techniques for Basic Bucking, Limbing, Pruning and Felling
7.4

Pruning

Pruning is selectively removing branches from a standing
tree.
WARNING
￭ To reduce the risk of injury from loss of control:
– Do not use the chain saw one-handed.
– Never work on a ladder, on a roof, in a tree or while
standing on any other insecure support.
– Never operate the chain saw above shoulder height
or cut overhead.
– Do not overreach.
– If you are unable to follow these instructions, you
must use a different tool, such as a pole pruner, or
have the work performed by a reputable tree service.
￭ To reduce the risk of injury:
– Never stand directly underneath the branch you are
cutting.
– Watch for falling branches. As soon as the branch
starts to fall, step aside and keep a sufficient
distance away from the falling wood. A branch may
spring back at you after it hits the ground.
– Prior to beginning work, clear the work area of limbs
and brush to reduce the risk of tripping and losing
control of the chain saw.
To cut branches from a standing tree:
1
0458-729-8221-A
2
► Make the first cut (1) on the underside of the branch,
approximately 2 in. (5 cm) from the trunk. Cut through
approximately 1/4 of the diameter of the branch. This will
help prevent the branch from splintering after it is cut.
► Make the second cut (2) on the top side of the branch,
approximately 2 in. (5 cm) from the first cut.
► As soon as the branch starts to fall, withdraw the chain
saw and let the branch fall to the ground.
7.5

Cutting Logs Under Tension

1
2
WARNING
￭ There is an increased danger of pinching the chain saw
when cutting logs under tension. The tension in wood can
also release suddenly and with great force, propelling the
log, limb or chain saw into the saw operator, causing injury
or loss of control.
￭ To reduce the risk of severe or fatal personal injury from
reactive forces, including kickback, or loss of control when
cutting wood under tension:
– Always start with a relieving cut (1) at the
compression side of the log, and then make a
bucking cut (2) at the tension side.
– If a pinch occurs that traps the bar/chain, switch off
the motor, activate the chain brake and disconnect
the saw from the power supply before attempting to
remove the saw from the log, exercising caution that
the limb does not suddenly snap or release.
English
2
1
23