Cutting Attachment; Mount Guide Bar And Diamond Abrasive Chain - Stihl GS 461 Instruction Manual

Cutting Attachment

Diamond abrasive chain, guide bar and
chain sprocket make up the cutting
attachment.
The cutting attachment that is supplied
has been optimized for the concrete
cutter.
1
a
t = a : 2
The pitch (t) of the diamond
–
abrasive chain (1), chain sprocket
and sprocket nose of the Rollomatic
guide bar must match
The drive link gauge (2) of the
–
diamond abrasive chain (1) must be
matched to the groove width of the
guide bar (3)
When pairing components that are not
compatible with each other, the cutting
attachment may become damaged
beyond repair after only a short period of
operation.
Diamond abrasive chain
The correct use of the STIHL diamond
abrasive chain ensures economical use
and avoids accelerated wear.
GS 461
The STIHL diamond abrasive chain is
suitable for cutting the following
materials:
Concrete
–
Reinforced concrete
–
General blocks
–
Masonry
–
Stone pipes
–
Abrasive stone*, e. g. asphalt and
–
bricks (sandstone)
2
Hard stone*, granite*
–
ductile cast iron pipes*
–
*) Restrictions on power and service life
3
are possible
Do not cut any other materials – risk of
accident!
Chain scabbard
The product contents includes a chain
scabbard that is suitable for the bar and
chain.
Mount Guide Bar and
Diamond Abrasive Chain
Removing the chain sprocket cover
1
2
Unscrew nuts (1) from the studs –
N
nuts are fastened to the chain
sprocket cover so that they are
secured against loss
Remove chain sprocket cover (2)
N
3
4
Turn the screw (3) to the left until
N
the tensioner slide (4) butts against
the left end of the housing slot
English
1
11