Advertisement
,WIRING
DONE
ACCORDING
TO
NATIONAL
ELECTRICAL
CODE
AND
APPLICABLE
LOCAL
CODES1
RECEPTACLE
TERMINAL
ACCESS
COYER
Figure 13
FILTER
CLIPS
INSTALLING
MICROWAVE
OVEN
1. Place the microwave
oven on the shelf hood in the center
of the hood.
2. Use the leveling bolts provided to level the shelf hood after
the weight of the appliance
is placed on it. Bolts are provided
in the installation
Assembly.
Screw the bolts into the nuts
Figure 14
provided
on the lower left and right hand sides of the hood
until the unit is level. (Figure 14) Use
a
level.
NOTE: The leveling
bolts have a 9116" Hex Head.
CAUTION:
The mlcrowave
oven must be level from front to
back to minimize
utensils from sliding forward when openlng
the door.
WARNING:
THE
WEIGHT
OF THE
MICROWAVE
MAY
EXCEED
YOUR
LIFTING
ABILITY.
WE RECOMMEND
ASSISTANCE.
3. Replace front panel. (Figure 10)
LIGHTING
Select two light bulbs up to 60 watts each to achieve
the
desired lighting.
The bulbs may be installed or removed by removing
the filter.
FILTER REMOVAL
AND
INSTALLATION
The aluminum
filter is held in place with the two filter clips
located on the front panel. (See illustrations
below).
To remove the filter, simply turn the filter clips to the front of
the hood. The filter can now be removed.
To replace the filter, place one end of the filter beneath the
back flange of the panel and set filter in position.
The filter
will set over the blower housing with the other end flush on
the lower flange of the front panel. Turn the filter clips to the
rear until the filter is secure.
FILTER
INSTALLED
Figure 15
FILTER CLIP /
-~ -\
FRONT
Figure 16
BLOWER
HOUSING
F'LTER
FILTER INSTALLATION
Figure 17
Once the filter is removed,
adequate
space is provided
on
either side of the filter area for installation
or removal of the
bulbs by hand.
Page 5
Advertisement
